. "Influence of the Mass of the Weight on the Dynamic Response of the Simple Mechanical System with Fibre" . "5"^^ . . . "Experimental measurements focused on the investigation of a fibre behaviour are performed on an assembled weigh-fibre-pulley-drive mechanical system. The carbon fibre (of the length 1.82 meters), which is driven with one drive, is led over a pulley. On its other end there is a prism-shaped steel weight (of the weight 3.096 kg), which moves in prismatic linkage on an inclined plane. The position of the weight can be symmetric or asymmetric with respect to the plane of drive-pulley symmetry (in presented case symmetric position is considered). It is possible to add an extra mass (of the weight 5.035 kg) to the weight. Drive excitation signals can be of a rectangular, a trapezoidal and a quasi sinusoidal shapes with a possibility of variation of a signal rate. Time histories of the weight position, of the drive position and of the force acting in the fibre are measured." . . "Fibres; Modelling; Measurement; Experiment"@en . "RIV/68407700:21220/13:00216636" . . "RIV/68407700:21220/13:00216636!RIV14-GA0-21220___" . . "Influence of the Mass of the Weight on the Dynamic Response of the Simple Mechanical System with Fibre"@en . "Influence of the Mass of the Weight on the Dynamic Response of the Simple Mechanical System with Fibre" . . "Polach, P." . . . "Haj\u017Eman, M." . . "2"^^ . . . "Influence of the Mass of the Weight on the Dynamic Response of the Simple Mechanical System with Fibre"@en . "Val\u00E1\u0161ek, Michael" . . . "79996" . "P(GAP101/11/1627)" . "V\u00E1clav\u00EDk, J." . . "[22F69E5B7325]" . . . "\u0160ika, Zbyn\u011Bk" . . "21220" . "Experimental measurements focused on the investigation of a fibre behaviour are performed on an assembled weigh-fibre-pulley-drive mechanical system. The carbon fibre (of the length 1.82 meters), which is driven with one drive, is led over a pulley. On its other end there is a prism-shaped steel weight (of the weight 3.096 kg), which moves in prismatic linkage on an inclined plane. The position of the weight can be symmetric or asymmetric with respect to the plane of drive-pulley symmetry (in presented case symmetric position is considered). It is possible to add an extra mass (of the weight 5.035 kg) to the weight. Drive excitation signals can be of a rectangular, a trapezoidal and a quasi sinusoidal shapes with a possibility of variation of a signal rate. Time histories of the weight position, of the drive position and of the force acting in the fibre are measured."@en .