"Zl\u00EDn" . . "Zl\u00EDn" . "RIV/46747885:24210/11:#0002306" . "4"^^ . . "Injection mold for plastics injection molding with over pressure and vacuum in mold cavity"@en . "[521F2C68EBAC]" . . "24210" . "1"^^ . . . "978-80-7454-013-4" . "Mezin\u00E1rodn\u00ED Ba\u0165ova konference pro doktorandy a mlad\u00E9 v\u011Bdeck\u00E9 pracovn\u00EDky" . . "1"^^ . . "For some plastic injected molded products is possible to use over pressure or vacuum in mold cavity and by this way to reach process advantages. In case o vacuum and thin wall products it is for example better cavity filling. In case of over pressure in mold cavity it is more uniform filling and partial substitution of conventional holding phase and thus cycle time reduction. Presently is for pressure condition setup often used special valve whose surface is part of cavity surface. This way is not so effective. In this paper is described new pressure setup in mold cavity way. This solution is patented with czech patent no. 302273." . "204877" . "2011-04-12+02:00"^^ . . "RIV/46747885:24210/11:#0002306!RIV12-MSM-24210___" . . . . "For some plastic injected molded products is possible to use over pressure or vacuum in mold cavity and by this way to reach process advantages. In case o vacuum and thin wall products it is for example better cavity filling. In case of over pressure in mold cavity it is more uniform filling and partial substitution of conventional holding phase and thus cycle time reduction. Presently is for pressure condition setup often used special valve whose surface is part of cavity surface. This way is not so effective. In this paper is described new pressure setup in mold cavity way. This solution is patented with czech patent no. 302273."@en . . "S" . . . "Injection mold for plastics injection molding with over pressure and vacuum in mold cavity"@en . "Injection mold for plastics injection molding with over pressure and vacuum in mold cavity" . "Univerzita Tom\u00E1\u0161e Bati ve Zl\u00EDn\u011B" . "Injection mold for plastics injection molding with over pressure and vacuum in mold cavity" . . "Bobek, Ji\u0159\u00ED" . . . . "cavity, cycle time, injection molding, over pressure, reduction"@en .