"RIV/44555601:13420/13:43885364!RIV14-MSM-13420___" . "Svobodov\u00E1, Jaroslava" . . . "Cais, Jarom\u00EDr" . "978-605-5343-81-1" . . "Al-Si Alloys are a leading casting alloys based on aluminum. Machining of aluminum alloys is currently frequently used and it is an important area of production. The paper deals with an experiment, that was realized at the Faculty of Production Technology and Management, University of Jan Evangelista Purkyn\u011B in \u00DAst\u00ED nad Labem, where was machined alloy AlSi7Mg0.3. Samples were made for machining because of the master alloys of AlSi7Mg0.3, where part of the castings was left in its original condition and part of the castings was modified by strontium. This paper describes the evaluation of surface roughness and tool wear obtained after machining of these castings in terms of how the modification by strontium can affect this." . "1" . . . . "I" . . "[71231B973518]" . . . . "Toyotarity. Technologies Management" . "12"^^ . . "Influence of AlSi7Mg0,3 modification by Sr to its machining process quality"@en . "3"^^ . . . "Influence of AlSi7Mg0,3 modification by Sr to its machining process quality"@en . "79666" . "Influence of AlSi7Mg0,3 modification by Sr to its machining process quality" . "131"^^ . "Sava\u015F Kitap ve Yayinevi" . "Ankara" . "RIV/44555601:13420/13:43885364" . "3"^^ . . "N\u00E1prstkov\u00E1, Nata\u0161a" . . . "Influence of AlSi7Mg0,3 modification by Sr to its machining process quality" . . . "13420" . . "modification, machining, tool wear, roughness, cutting insert"@en . "Al-Si Alloys are a leading casting alloys based on aluminum. Machining of aluminum alloys is currently frequently used and it is an important area of production. The paper deals with an experiment, that was realized at the Faculty of Production Technology and Management, University of Jan Evangelista Purkyn\u011B in \u00DAst\u00ED nad Labem, where was machined alloy AlSi7Mg0.3. Samples were made for machining because of the master alloys of AlSi7Mg0.3, where part of the castings was left in its original condition and part of the castings was modified by strontium. This paper describes the evaluation of surface roughness and tool wear obtained after machining of these castings in terms of how the modification by strontium can affect this."@en .