"The laboratory setup for calibrating of the surface temperature sensors"@en . "1"^^ . "2010-01-01+01:00"^^ . "Strnad, Radek" . . . "978-961-243-146-4" . "Surface"@en . "267784" . . "The laboratory setup for calibrating of the surface temperature sensors" . "[764FC0578312]" . . "The laboratory setup for calibrating of the surface temperature sensors"@en . . . "\u0160indel\u00E1\u0159, Martin" . . . "The laboratory setup for calibrating of the surface temperature sensors" . "Portoro\u017E" . "Portoro\u017E" . "2"^^ . "RIV/00177016:_____/10:#0000478" . "The calibration of the surface temperature sensors depends on number of influencing parameters including the calibrated sensor, design of the surface, ambient environment and methods of the calibration. The results also often depend on the operator experiences. In this article will be presented the laboratory setup for surface temperature calibration at \u010CMI. The design is based on the block of compact material with 4pc of industrial platinum resistance thermometers (IPRT) to measure the temperature gradient along the block. These measurements were used for extrapolation of the surface temperature. In the experimental part will be showed the comparison of this block with the commercial system used at \u010CMI. It will be also shown the influence of different block materials and different designs to the results. The investigation on the external environment was made. The results were compared with numerical analysis and the uncertainty budged will be presented."@en . . . . "V" . "The calibration of the surface temperature sensors depends on number of influencing parameters including the calibrated sensor, design of the surface, ambient environment and methods of the calibration. The results also often depend on the operator experiences. In this article will be presented the laboratory setup for surface temperature calibration at \u010CMI. The design is based on the block of compact material with 4pc of industrial platinum resistance thermometers (IPRT) to measure the temperature gradient along the block. These measurements were used for extrapolation of the surface temperature. In the experimental part will be showed the comparison of this block with the commercial system used at \u010CMI. It will be also shown the influence of different block materials and different designs to the results. The investigation on the external environment was made. The results were compared with numerical analysis and the uncertainty budged will be presented." . . "Tempmeko" . . "2"^^ . "RIV/00177016:_____/10:#0000478!RIV12-MPO-00177016" . . "IMEKO TC 12" .